C2-2000 units with the ability to genlock to a composite video source also have a H/V Shift adjustment in the Adjust outputs menu.
These units are:
C2-2100
C2-2105
C2-2150
C2-2155
C2-2350
C2-2355
In order to get precise alignement of the composite video output with the input when Genlock is active, it is recommended to use the following H/V Shift values:
(Note that the units ending in '5', those with SDI outputs, you must set 'Optimize for SDI = Off'.)
Please be aware that in Lock&Mix mode, you can't align the lock source's syncs at the same time as getting the video content aligned, in which case you must put the H/V Shift back to 0.
Articles in this section
- Using Presets On The C2 products
- Which CORIO2 products support HDCP?
- HDCP additions to C2-2000A series
- HDCP Restrictions On CORIO2 Units
- Resolutions Not Detected Correctly - Everything Shows As 1920x1200
- HDCP Not Working On CORIO2 Unit
- Frame Rate Conversion In CORIO2 Products
- Using the Lock Source
- EDID Manager In CORIO2 Units
- HDMI Input / Output Support