The Lock Source allows selection of the input used as the basis for genlocking, picture in picture, overlay and underlay.
You can choose any input connector, completely independently of Program source or Preview source - however it only becomes active when the Lock method is set to anything other than 'Off', at which point the scaler's Output image and type are locked to the Lock source (and thus the Output image is no longer adjustable).
In general: the Lock source is the background when in PIP or Overlay mode; and the foreground when in Underlay mode.
Articles in this section
- Using Presets On The C2 products
- Which CORIO2 products support HDCP?
- HDCP additions to C2-2000A series
- HDCP Restrictions On CORIO2 Units
- Resolutions Not Detected Correctly - Everything Shows As 1920x1200
- HDCP Not Working On CORIO2 Unit
- Frame Rate Conversion In CORIO2 Products
- Using the Lock Source
- EDID Manager In CORIO2 Units
- HDMI Input / Output Support